Azure NAT Gateway

-

 

Comments

Post a Comment

Popular posts from this blog

IRF Step up (Stacking Technology) on HP 5130 Swtiches

-
Image
IRF Step up (Stacking Technology) on HP 5130 Swtiches IRF ( Intelligent Resilient Framework) considers two HP swtiches as one.  With this technology,  you can build a stack using  the  Ethernet port  without requiring dedicated stack port. Advantages of IRF (Stacking) on HP switches no additional stack port like other vendor switches can use any port for stack configuration I don't want to explain more about Stacking. I assume that you will have more experience in stacking technology.  In this article, i gonna explain about how to stack (IRF) on HP FlexNetwork 5130 Switches. Requirements for making IRF,  -Two pairs of HP X240 SFP+ SFP+ DAC Cable  -Both switches mush have the same firmware  Check the firmware on both switches. Checking switch-1 firmware. Checking switch-2 firmware both switches have the same firmware. So let go to IRF Port configuration.  Check MemeberID, Role and Priorit...
Read more

SOPHO UTM initial Configuration Part2

-
Image
After you initial setup on UTM (  https://phonemyintmyatzaw7.blogspot.com/2020/08/utm-97-initial-configuration.html ), you have to do the next step that I described below. Go to UTM WebAdmin Page by browsing https://192.168.108.251:4444.  Firstly, You have to setup initial configuration like hostname, admin password, email address and so on.   After filling the above information, accept the end user license agreement and  click perform basic system setup. It will take a few minute and your UTM will reboot a while. After logon into your UTM, you will see two option:  Continue - If you want to setup all fresh configuration, you should choose this option. Restore a backup - If you had UTM backup file, you can use this option and can try to restore from a backup. In my demo, I don't use a backup so I choose "continue" option and Click "Next". Below step is a license information tab, you can browse or input your license file if yo...
Read more

Cisco 819 4G LTE Cellular Router Configuration

-
Image
Cisco 819 4G LTE Cellular Router Configuration In this article, i will use MPT  sim card to access 4G internet for my LAN Users. (1) Insert MPT sim card in slot 0 at the back of the router. (3) Install 4G LTE Antenna as shown in figure and connect console cable to your laptop. (4) Configure 819 4G LTE Cellular Router login into the router and set hostname Username: cisco Password: % Password expiration warning. ----------------------------------------------------------------------- Cisco Configuration Professional (Cisco CP) is installed on this device and it provides the default username "cisco" for  one-time use. If you have already used the username "cisco" to login to the router and your IOS image supports the "one-time" user option, then this username has already expired. You will not be able to login to the router with this username after you exit this session. It is strongly suggested that you create a new username ...
Read more