Go to UTM WebAdmin Page by browsing https://192.168.108.251:4444.
- Firstly, You have to setup initial configuration like hostname, admin password, email address and so on.
- After filling the above information, accept the end user license agreement and click perform basic system setup. It will take a few minute and your UTM will reboot a while.
- After logon into your UTM, you will see two option:
- Continue - If you want to setup all fresh configuration, you should choose this option.
- Restore a backup - If you had UTM backup file, you can use this option and can try to restore from a backup. In my demo, I don't use a backup so I choose "continue" option and Click "Next".
- Below step is a license information tab, you can browse or input your license file if you have or you can input the license file later. (Note : SOPHO will give you 30-days trial license for demo purpose). In this demo, I will input my license file later and so leave it and click "Next".
- In this step, you have to configure your Local LAN Network IP Address. We'll use this ip address for browsing UTM Web Interface.
- Enable DHCP Server on internal interface means if your want to setup dhcp server on the interface, you can enable this option and assign DHCP Address start range and End range and so on.
- Assign your ISP (WAN) IP Address. You can choose Static or Dynamic type according your requirement.
- This tab is related to Firewall Rule. You can choose the firewall rule which you want to allow your internal address to any. For example, if you choose Web(http,https), UTM will allow your internal network to Any destination by using port 80 and port 443).
- You can even configure Advance Threat Protection Setting in this step or late.
- For web protection setting, you can choose any option which you want to block or filter by UTM.
- Here is your Configuration Summary tab.
Hope for enjoy learning.
Best Regards,
Phone Myint Myat Zaw
30-08-2020(5:44PM)
No comments:
Post a Comment